Keysight Technologies D9010USBC

The D9010USBC USB compliance test software for Infiniium oscilloscopes gives you a fast and reliable way to verify USB electrical specification compliance for your USB 2.0 devices, hosts and hubs. The software executes the official USB-IF software, USBET20 embedded in the oscilloscope.

The D9010USBC USB 2.0 Compliance test software makes USB signal integrity testing as simple as capturing the signals with your oscilloscope; eliminating the need to transfer scope waveforms to a PC.

Automation:

• Test setup wizard guides you through test selection, configuration, connection, execution, and results reporting
• Measurement connection setups are displayed
• Oscilloscope setup is automatically configured for each test
• Test results report documents test configuration, measurements made, pass/fail status, margin analysis, and waveforms

Standards Supported:

• USB-IF recognized for use in USB 2.0 compliance testing
• MATLAB scripts used are from the USB-IF organization

Requirements:

• E2649B for a complete set of six high-speed test fixtures and power supply
• E2646A Signal Quality inrush Droop/Drop (SQiDD) for low/full speed testing