Next-generation ADAS systems require camera and radar systems with increasingly high resolution. That means new requirements for speed and bandwidth. Automotive Ethernet enables faster data communication to meet the demands of today’s vehicles and the connected vehicles of the future. Unlike CAN, LIN or MOST, the IEEE standard for Automotive Ethernet demands rigorous compliance verification using test cases that cover transmitters (Tx), receivers (Rx) and harness/connector assemblies.
The requirements include complex measurements that, until recently, have been uncommon in the auto industry: vector network analysis with S-parameters; and bit error rate (BER) testing and protocol analysis of high-speed digital signals. To help you save time and effort, Keysight offers solutions that automate the testing and validation of Automotive Ethernet designs. Our engineers have invested countless hours in learning the standards and creating automated compliance tests.
These proven applications help ensure proper test configuration and valid, repeatable measurement results. The net result: you’ll have greater confidence that your device is compliant with the IEEE standard, a faster development cycle, repeatability of testing and less human error.
Key Features:
- Receiver tests verify BER, SQI and Alien Crosstalk Noise Rejection
- Automated setups ensure result repeatability and enable your team to run tests without becoming an expert on the required procedures
- Test setup wizard guides the user through test selection, configuration, connection, execution and reporting
- Reports document the configuration, measurements, pass/fail results, margin analysis, and waveforms
Supported Instruments
- 81160A Pulse function arbitrary noise generator
- M8190A 12 GSa/s Arbitrary Waveform Generator
Supported Standards
