4-Port Test Set; K Connectors (2.92 mm), 70 kHz* to 20/40 GHz (Note: * Operational to 40 kHz)
The Anritsu MN469xC Series Multiport Test Set provides multiple test port capabilities for the Anritsu VectorStar MS464xB/MS464xA Series Vector Network Analyzer.
The MN469xC Series Test Set contains a switch matrix and switch matrix controller that facilitates multiple test port connections to the device under test. The test set is controlled by the connected VectorStar VNA (except for power on/off) via the IEEE-488 General Purpose Interface Bus (GPIB).
The MN469xC Series Test Sets only contribute loss to the source and test paths, and uncorrected (raw) port directivity and match. Therefore, system performance is specified when connected to a base 2-port VectorStar VNA with option 51 (Direct Access Loops). If additional options are added to the base VectorStar VNA that affect its port performance, those effects must also be added to these system specifications. Specifically, adding option 6x, Active Measurement Suites will affect available test port power and dynamic range.
| Specifications |
|
MN469xC Series
Vector Network Analyzer Multiport Test Sets
|
|
| Model Overview |
|
| Model | Description |
| MN4694C | 4-Port Test Set, K Connectors
For use with MS4642A/B*: 70 kHz** to 20 GHz
For use with MS4644A/B*: 70 kHz** to 40 GHz
Standard Accessories:
Interface cables to base VNA (6 each)
GPIB cable to base VNA
Power cord
Installation instructions
(manuals are covered in the base VNA manuals)
|
| MN4697C | 4-Port Test Set, V Connectors
For use with MS4645A/B*: 70 kHz** to 50 GHz
For use with MS4647A/B*: 70 kHz** to 70 GHz
Standard Accessories:
Interface cables to base VNA (6 each)
GPIB cable to base VNA
Power cord
Installation instructions
(manuals are covered in the base VNA manuals)
|
Notes:
* Base VNA must include the optional Direct Access Loops, available with option 051 or 06x.
** Operational to 40 kHz; Requires Base VNA to include Option 070, otherwise cannot be operated below 10 MHz. For accessories such as calibration solutions and test port cables, please refer to the base VNA data sheet and configuration guide. All calibration kits that are available for the 2-port VNA are usable with the 4-port solution, including the 2-port precision AutoCal. The available verification kits only support the verification of the 2-port base VNA.
